Experimental study on one-shot moulding method for preparation of irregular columnar jointed rock mass
XIAO Wei-min1,2, HUANG Wei1,2, HAN Jun-cheng1,2, TIAN Meng-ting1,2
1. School of Civil Engineering, Sichuan Agricultural University, Dujiangyan 611830, China; 2. Sichuan Higher Education Engineering Research Center for Disaster Prevention and Mitigation of Village Construction, Dujiangyan 611830, China
Abstract：In view of the deficiencies of low-efficiency and poor mechanical response of columnar joint existing in the physical model tests on irregular columnar jointed rock mass, a one-shot moulding method for preparing artificial irregular columnar jointed rock mass specimens is proposed based on the Voronoi diagram random simulation and the 3D printing technology. Then brittle green wax is used as the 3D printing material to print the irregular columnar joint network, and the irregular columnar jointed rock mass specimens are prepared. Then uniaxial compression tests are performed on the above specimens, and the uniaxial compressive strength, deformation modulus and failure morphology of the specimens are obtained. On this basis, the mechanical anisotropy characteristics and typical failure modes under uniaxial compression are analyzed. Furthermore, the above experimental results are compared with the existing model test ones. It is shown that the proposed one-shot moulding method can improve the efficiency of sample preparation and simulate the mechanical response of real columnar joints very well.
肖维民, 黄巍, 韩俊成, 田梦婷. 不规则柱状节理岩体一次成型制备方法试验研究[J]. 岩土工程学报, 2020, 42(s2): 106-111.
XIAO Wei-min, HUANG Wei, HAN Jun-cheng, TIAN Meng-ting. Experimental study on one-shot moulding method for preparation of irregular columnar jointed rock mass. Chinese J. Geot. Eng., 2020, 42(s2): 106-111.
[1] 徐松年. 火山岩柱状节理构造研究[M]. 杭州: 杭州大学出版社, 1995. (XU Song-nian.Study on Columnar Jointing Structure in Volcanic Rocks[M]. Hangzhou: Hanzhou University Press, 1995. (in Chinese)) [2] SPRY A.The origin of columnar jointing, particularly in basalt flows[J]. Journal of Australian Geological Society, 1962, 8(2): 192-216. [3] RYAN M P, SAMMIS C G.Cyclic fracture mechanisms in cooling basalt[J]. Geological Society of America Bulletin, 1978, 89(9): 1295-1308. [4] KANTHA L H.‘Basalt fingers’-origin of columnar joints?[J]. Geology Magzine, 1981, 118(3): 251-264. [5] 王江海, 吴金平, 王人镜. 福建镇海一带玄武岩柱状节理的动力学研究兼论柱状节理的成因[J]. 岩石学报, 1991(1): 16-25. (WANG Jiang-hai, WU Jin-ping, WANG Ren-jing.Dynamics of columnar joints in basalt, Zhenhai area, Fujian province, with special reference to its genesis[J]. Acta Petrologica Sinica, 1991(1): 16-25. (in Chinese)) [6] 卢轶然. 柱状节理玄武岩变形各向异性研究[D]. 武汉: 长江科学院, 2010. (LU Yi-ran.Deformation Anisotropy Study of Columnar Jointed Rock Masses[D]. Wuhan: Changjiang River Scientific Research Institute, 2010. (in Chinese)) [7] 张宜虎, 周火明, 钟作武, 等. YXSW-12现场岩体真三轴试验系统及其应用[J]. 岩石力学与工程学报, 2011, 30(11): 2312-2320. (ZHANG Yi-hu, ZHOU Huo-ming, ZHONG Zuo-wu, et al.In situ rock masses triaxial test system YXSW-12 and its application[J]. Chinese Journal of Rock Mechanics and Engineering, 2011, 30(11): 2312-2320. (in Chinese)) [8] 朱道建, 杨林德, 蔡永昌. 柱状节理岩体各向异性特性及尺寸效应研究[J]. 岩石力学与工程学报, 2009, 28(7): 1405-1414. (ZHU Dao-jian, YANG Lin-de, CAI Yong-chang.Research on anisotropic characteristics and size effect of columnar jointed rock mass[J]. Chinese Journal of Rock Mechanics and Engineering, 2009, 28(7): 1405-1414. (in Chinese)) [9] 徐卫亚, 郑文堂, 宁宇, 等. 柱状节理坝基岩体三维各向异性数值分析[J]. 岩土力学, 2010, 31(3): 949-955. (XU Wei-ya, ZHENG Wen-tang, NING Yu, et al.3D anisotropic numerical analysis of rock mass with columnar joints for dam foundation[J]. Rock and Soil Mechanics, 2010, 31(3): 949-955. (in Chinese)) [10] 刘海宁, 王俊梅, 王思敬. 白鹤滩柱状节理岩体真三轴模型试验研究[J]. 岩土力学, 2010, 31(增刊1): 163-171. (LIU Hai-ning, WANG Jun-mei, WANG Si-jing.Experimental research of columnar jointed basalt with true triaxial apparatus at Baihetan Hydropower Station[J]. Rock and Soil Mechanics, 2010, 31(S1): 163-171. (in Chinese)) [11] 肖维民, 邓荣贵, 付小敏, 等. 单轴压缩条件下柱状节理岩体变形与强度各向异性的模型试验研究[J]. 岩石力学与工程学报, 2014, 33(5): 957-963. (XIAO Wei-min, DENG Rong-gui, Fu Xiao-min, et al.Model studies on deformation and strength anisotropy of columnar jointed rock masses under uniaxial compression condition[J]. Chinese Journal of Rock Mechanics and Engineering, 2014, 33(5): 957-963. (in Chinese)) [12] JI H, ZHANG J C, XU W Y, et al.Experimental investigation of the anisotropic mechanical properties of a columnar jointed rock mass: observations from laboratory-based physical modelling[J]. Rock Mechanics and Rock Engineering, 2017, 50(7): 1919-1931. [13] LIN Zhi-nan, XU Wei-ya, WANG Wei, et al.Determination of strength and deformation properties of columnar jointed rock mass using physical model tests[J]. KSCE Journal of Civil Engineering, 2018, 22(9): 3302-3311. [14] 柯志强, 王环玲, 徐卫亚, 等. 含横向节理的柱状节理岩体力学特性试验研究[J]. 岩土力学, 2019, 40(2): 1-8. (KE Zhi-qiang, WANG Huan-ling, XU Wei-ya, et al.Experimental study of mechanical behaviour of artificial columnar jointed rock mass containing transverse joints[J]. Rock and Soil Mechanics, 2019, 40(2): 1-8. (in Chinese)) [15] LIN Zhi-nan, XU Wei-ya, WANG Huan-ling, et al.Anisotropic characteristic of irregular columnar-jointed rock mass based on physical model test[J]. KSCE Journal of Civil Engineering, 2017, 21(5): 1728-1734. [16] 杨涛, 卢文斌, 阙相成. 柱状节理岩体相似材料力学特性试验研究[J]. 河南科学, 2018, 36(4): 575-578. (YANG Tao, LU Wen-bin, QUE Xiang-cheng.Experimental study on mechanical properties of similar materials for columnar jointed rock masses[J]. Henan Science, 2018, 36(4): 575-578. (in Chinese)) [17] 宁宇, 徐卫亚, 郑文棠, 等. 柱状节理岩体随机模拟及其表征单元体尺度研究[J]. 岩石力学与工程学报, 2008, 27(6): 1202-1208. (NING Yu, XU Wei-ya, ZHENG Wen-tang et al. Study of random simulation of columnar jointed rock mass and its representative elementary volume scale[J]. Chinese Journal of Rock Mechanics and Engineering, 2008, 27(6): 1202-1208. (in Chinese))
