Strength criteria and slipping planes of anisotropic sand considering direction of major principal stress
DONG Tong1,2, ZHENG Ying-ren1,2, KONG Liang3, ZHE Mei4
1. Chongqing Key Laboratory of Geomechanics and Geoenvironmental Protection, Army Logistical University of PLA, Chongqing 401311, China; 2. Chongqing Engineering and Technology Research Center of Geological Hazard Prevention and Treatment, Chongqing 400041, China; 3. School of Sciences, Qingdao Technological University, Qingdao 266033, China; 4. Institute of Material Science and Engineering, Chongqing Jiao Tong University, Chongqing 400074, China;
Abstract：The effect of directions of the principal stress on the deformation and strength of sand is due to the anisotropy of soils. The shear strength on a certain plane of the cross-isotropic sand is larger when the angle between this plane and the bedding plane is larger. Assuming that the intrinsic anisotropy strength of sand is closely related to the anisotropy parameter of the plane, the peak strength of anisotropic soils is presented. As the shear-normal stress ratio of each potential slipping plane of the SMP criterion is the same, the shear strength and position of the slipping plane are determined by the potential slipping plane with the lowest shear strength. On this basis, an anisotropic strength criterion is proposed by considering the relationship among the principal stress axis, the slipping plane and the bedding plane. A series of shear tests with fixed direction of the major principal stress are carried out using Fujian standard sand in order to systematically observe the slipping plane of the specimens. Comparison between the predicted data and the measured results indicates that the anisotropic model can well reflect the strength and the position of the slipping plane of the anisotropic soils.
董彤, 郑颖人, 孔亮, 柘美. 考虑主应力轴方向的砂土各向异性强度准则与滑动面研究[J]. 岩土工程学报, 2018, 40(4): 736-742.
DONG Tong, ZHENG Ying-ren, KONG Liang, ZHE Mei. Strength criteria and slipping planes of anisotropic sand considering direction of major principal stress. Chinese J. Geot. Eng., 2018, 40(4): 736-742.
[1] 董彤, 郑颖人, 刘元雪, 等. 考虑主应力轴旋转的土体本构关系研究进展[J]. 应用数学和力学, 2013, 34(4): 327-335. (DONG Tong, ZHENG Ying-ren, LIU Yuan-xue, et al.Research progress of the soil constitutive relation considering principal stress axes rotation[J]. Applied Mathematics and Mechanics, 2013, 34(4): 327-335. (in Chinese)) [2] ARTHUR J R F, MENZIES B K. Inherent anisotropy in sand[J]. Géotechnique, 1972, 22(1): 115-128. [3] TONG Z, FU P, ZHOU S, et al.Experimental investigation of shear strength of sands with inherent fabric anisotropy[J]. Acta Geotechnica, 2014, 9(2): 257-275. [4] 蔡燕燕, 俞缙, 余海岁, 等. 加载路径对粗粒土非共轴性影响的试验研究[J]. 岩土工程学报, 2012, 34(6): 1117-1122. (CAI Yan-yan, YU Jin, YU Hai-sui, et al.Experimental study on effect of loading path on non-coaxiality of granular materials[J]. Chinese Journal of Geotechnical Engineering, 2012, 34(6): 1117-1122. (in Chinese)) [5] CAI Y, YU H S, WANATOWSKI D, et al.Non-coaxial behaviour of sand under various stress paths[J]. Journal of Geotechnical & Geoenvironmental Engineering, 2013, 139(8): 1381-1395. [6] 黄茂松. 土体稳定与承载特性的分析方法[J]. 岩土工程学报, 2016, 38(1): 1-34. (HUANG Mao-song.Analysis methods for stability and bearing capacity of soils[J]. Chinese Journal of Geotechnical Engineering, 2016, 38(1): 1-34. (in Chinese)) [7] 沈扬, 周建, 张金良, 等. 考虑主应力方向变化的原状黏土强度及超静孔压特性研究[J]. 岩土工程学报, 2007, 29(6): 843-847. (SHEN Yang, ZHOU Jian, ZHANG Jin-liang, et al.Research on strength and pore pressure of intact clay considering variation of principal stress direction[J]. Chinese Journal of Geotechnical Engineering, 2007, 29(6): 843-847. (in Chinese)) [8] LADE P V, DYCK E V, RODRIGUEZ N M.Shear banding in torsion shear tests on cross-anisotropic deposits of fine Nevada sand[J]. Soils and Foundations, 2014, 54(6): 1081-1093. [9] 童朝霞. 应力主轴循环旋转条件下砂土的变形规律与本构模型研究[D]. 北京: 清华大学, 2008. (TONG Zhao-xia.Research on deformation behavior and constitutive model of sands under cyclic rotation of principal stress axes[D]. Beijing: Tsinghua University, 2008. (in Chinese)) [10] MIURA K, MIURA S, TOKI S.Deformation behavior of anisotropic dense sand under principal stress rotation[J]. Soils and Foundations, 1986, 26(1): 36-52. [11] MATSUOKA H, JUN-ICHI H, KIYOSHI H.Deformation and failure of anisotropic sand deposits[J]. Soil Mechanics and Foundation Engineering, 1974, 32(11): 31-36. (in Japanese)) [12] 张连卫, 张建民, 张嘎. 基于SMP的粒状材料各向异性强度准则[J]. 岩土工程学报, 2008, 30(8): 1107-1111. (ZHANG Lian-wei, ZHANG Jian-min, ZHANG Ga.SMP- based anisotropic strength criteria of granular materials[J]. Chinese Journal of Geotechnical Engineering, 2008, 30(8): 1107-1111. (in Chinese)) [13] 姚仰平, 孔玉侠. 横观各向同性土强度与破坏准则的研究[J]. 水利学报, 2012, 42(1): 43-50. (YAO Yang-ping, KONG Yu-xia.Study on strength and failure criterion of cross-anisotropic soil[J]. Journal of Hydraulic Engineering, 2012, 42(1): 43-50. (in Chinese)) [14] 罗汀, 李萌, 孔玉侠, 等. 基于SMP的岩土各向异性强度准则[J]. 岩土力学, 2009, 30(增刊2): 127-131. (LUO Ting, LI Meng, KONG Yu-xia, et al.Failure criterion based on SMP for anisotropic geomaterials[J]. Rock and Soil Mechanics, 2009, 30(S2): 127-131. (in Chinese)) [15] MATSUOKA H.Stress-strain relationships of sands based on the mobilized plane[J]. Soils & Foundations, 1974, 14: 47-61. [16] LI X S, DAFALIAS Y F.Constitutive modeling of inherently anisotropic sand behavior[J]. Journal of Geotechnical & Geoenvironmental Engineering, 2002, 128(10): 868-880. [17] GAO Z, ZHAO J, YAO Y.A generalized anisotropic failure criterion for geomaterials[J]. International Journal of Solids & Structures, 2010, 47(22/23): 3166-3185. [18] 曹威, 王睿, 张建民. 横观各向同性砂土的强度准则[J]. 岩土工程学报, 2016, 38(11): 2026-2032. (CAO Wei, WANg Rui, ZHANG Jian-min.New strength criterion for sand with cross-anisotropy[J]. Chinese Journal of Geotechnical Engineering, 2016, 38(11): 2026-2032. (in Chinese)). [19] DONG T, ZHE M.Controlling and realizing of generalized stress paths in HCA test[J]. Electronic Journal of Geotechnical Engineering, 2016(21): 5269-5283
