Abstract:In order to study the mechanical characteristics of pipes during steel curved pipe jacking under large buried depth, the axial strain and hoop strain of curved pipe jacking are monitored and analyzed through site tests, based on the curved pipe jacking roof of Gongbei tunnel. The results show that the strain of pipe slightly increases with the increase of jacking distance, and maintains a certain range. The stress curve of pipe fluctuates in the process of jacking, but gradually restores stability after jacking stoppage. The axial stress of pipe is mainly affected by the jacking force, and the hoop stress mainly depends on the ring load out of pipe. Pressure stress concentration is located inside the pipe jacking curve. Under large buried depth, the axial stresses of pipe top and bottom are controlled by the circumference deformation because of Poisson effect. With the increasing distance between the pipe and the jacking machine head, the mechanical characteristics of pipe change from axial compression at both sides to one-side compression. The compression occurs inside the pipe bending with more obvious stress concentration.
张鹏,王翔宇,曾聪,马保松. 深埋曲线钢顶管受力特性现场监测试验研究[J]. 岩土工程学报, 2016, 38(10): 1842-1848.
ZHANG Peng, WANG Xiang-yu, ZENG Cong, MA Bao-song. Site monitoring of mechanical characteristics of pipes during steel curved pipe jacking under large buried depth. Chinese J. Geot. Eng., 2016, 38(10): 1842-1848.
[1] RÖHNER R, HOCH A. Calculation of jacking force by new ATV A-161[J]. Tunnelling and Underground Space Technology, 2010(25): 731-735. [2] HASLEM R F. Stress formulation for joints in pipe-jacked tunnels[J]. Trenchless Technol, 1998, 12(1): 39-48. [3] CECS246—2008 给水排水工程顶管技术规程[S]. 2008. (CECS246—2008 Technical specification for pipe jacking of water supply and sewerage engineering[S]. 2008. (in Chinese)) [4] 陈建中. 玻璃纤维增强塑料顶管接头受力分析[D]. 武汉:武汉理工大学, 2010. (CHEN Jian-zhong. Analysis the force of glass fiber reinforced plastics jacking pipe joints[D]. Wuhan: Wuhan University of Technology, 2010. (in Chinese)) [5] 金文航. 长距离曲线顶管技术分析与研究[D]. 杭州: 浙江大学, 2005. (JIN Wen-hang. Analysis of long-distance curve pipe jacking texhnology[D]. Hangzhou: Zhejiang University, 2005. (in Chinese)) [6] 熊 翦. 矩形顶管关键受力分析[D]. 北京: 中国地质大学2013. (XIONG Jian. Analysis of critical mechanics od rectangular pipe jacking[D]. Beijing: China University of Geosciences, 2013. (in Chinese)) [7] 赵志峰, 邵光辉. 顶管施工中钢管管壁稳定性分析及壁厚的优化[J]. 武汉大学学报 (工学版), 2011, 44(4): 481-486. (ZHAO Zhi-feng, SHAO Guang-hui. Stability analysis of wall stability of steel pipe in pipe-jacking and optimization of proper wall thickness[J]. Engineering Journal of Wuhan University, 2011, 44(4): 481-486. (in Chinese)) [8] ZHOU Jian-qing. Numerical analysis and laboratory test of concrete jacking pipes[D]. Oxford: University of Oxford, 1998. [9] 薛振兴. 顶管施工顶力计算与力学特性研究[D]. 北京: 中国石油大学, 2010. (XUE Zhan-xing. Investigation on jacking force calculation and mechanical properties of pipe jacking construction[D]. Beijing: China University of Petroleum, 2010. (in Chinese)) [10] 陈 楠. 复杂环境中大直径钢顶管的受力特性研究[D]. 上海: 上海交通大学, 2012. (CHEN nan. Mechanical characteristics of steel pipe-jacking with large diameter in complex environment[D]. Shanghai: Shanghai Jiao Tong University, 2012. (in Chinese)) [11] MILLIGAN G W E, NORRIS P. Site based research in pipe jacking-objectives, procedures and a case history[J]. Tunnelling and Underground Space Technology, 1996, 11(1): 3-24. [12] MILLIGAN G W E, NORRIS P. Pipe-soil interaction during pipe jacking[J]. Geotechnical Engineering, 1999, 137(1): 27-44. [13] 冯海宁, 温晓贵, 魏 纲, 等. 顶管施工对土体影响的现场试验研究[J]. 岩土力学, 2003, 24(5): 781-785. (FENG Hai-ning, WEN Xiao-gui, WEI Gang et al. In-situ test research on influence of pipe jacking on soil[J]. Rock and Soil Mechanics, 2003, 24(5): 781-785. (in Chinese)) [14] 魏 纲, 徐日庆, 余剑英, 等. 顶管施工中管道受力性能的现场试验研究[J]. 岩土力学, 2005, 26(8): 1273-1277. (WEI Gang, XU Ri-qing, YU Jian-ying, et al. Site-based experimental study on pipe behavior during pipe jacking[J]. Rock and Soil Mechanics, 2005, 26(8): 1273-1277. (in Chinese)) [15] 潘同燕. 大口径急曲线顶管施工力学分析与监测技术研究[D]. 上海: 同济大学, 2000. (PAN Tong-yan. Research of mechanics analysis and monitoring technology during large diameter sharp curved pipe jacking construction[D]. Shanghai: Tongji University, 2000. (in Chinese)) [16] 杨 仙. 管幕预筑法中密排大直径钢管群顶进研究[D]. 长沙: 中南大学, 2012. (YANG Xian. Research of large diameter jacking-pipes with small space in pipe-roof pre-construction method[D]. Changsha: Central South University, 2012. (in Chinese)) [17] 余 晶, 程 勇, 贾瑞华. 港珠澳大桥珠海连接线拱北隧道方案论证[J]. 现代隧道技术, 2012, 49(1): 119-125. (YU Jing, CHENG Yong, JIA Rui-hua. Option demonstration for the gongbei tunnel at the Zhuhai Link of the Hong Kong-Zhuhai-Macau Bridge[J]. Rock and Soil Mechanics, 2012, 49(1): 119-125. (in Chinese)) [18] 胡向东, 任 辉, 陈 锦, 等. 管幕冻结法积极冻结方案模型试验研究[J]. 现代隧道技术, 2014, 51(5): 92-98. (HU Xiang-dong, REN Hui, CHEN Jin, et al. Model test study of the active freezing scheme for the combined pipe-roof and freezing method[J]. Modern Tunnelling Technology, 2014, 51(5): 92-98. (in Chinese)) [19] 李志宏, 李 剑. 曲线顶管管幕间相互影响研究[J]. 现代隧道技术, 2015, 52(3): 63-68. (LI Zhi-hong, LI Jian. A study of the interaction between the pipes of a curved pipe-roof[J]. Modern Tunnelling Technology, 2015, 52(3): 63-68. (in Chinese))